Beschreibung
Timecode In – Out: Converts both standard and frame rate. Any combination of 23.97 : 24 : 24.97 : 25 : 29.97 : 30 supported. Timecode Standard/Framerate ConverterTimecode Input any standard 24, 25(EBU), 30(SMPTE), DROP FRAMETimecode Output any standard 24, 25(EBU), 30(SMPTE), DROP FRAMEInput : Output Frame Rate Gearbox 23.97 : 24 : 24.97 : 25 : 29.97 : 30Switchable Timecode Generator Lock Source Reader, VideoRS232 Serial Interface ASCII Protocol6 Preset configurations Easy Setup for Repeat JobsTG-2AS TG-1 but with RS422 In and Out:Use with standards converter for making copies or will also slave PAL video @ 24fps..The Timecode Gearbox is used whenever you have to mix code standards, normally because someone has supplied you with an Audio or Video and a different standard or Frame rate:-Examples The M & E track has been supplied with 29.97 fps SMPTE timecode and you are working with 25 fps EBU timecode. You are dubbing the final mix to film at 24 fps and you are supplied with a dialogue tape recorded to 25fps Video. The Timecode Gearbox may also be used to change standard/timecode value without gearbox action. You are working with a system that does not recognise Drop frame code and you need to convert from Drop to Non Drop. You have almost finished your Mix and a new video is supplied with a different timecode. The Synchronizer section of the TG-1 may be used to synchronize any non-linear VTR (V-Mod, V-1, Viper) or Dynamic scan VTR at a different frame rate. You wish to prepare the music tracks for a 24fps film to a 25fps PAL video, you can use the TG-1 to slave the Video to 24fps so that there is no pitch shift on the final version.
